Go-power GP-SW1000 User Manual download pdf (Page 16)

GPSW-1000/2000/3000

___________________________________________________________

16



95 W 210 W ON OFF ON

115 W 245 W OFF ON ON

135 W 280 W ON ON ON

To disable power saving, leave dip switches S1, S2 and S3 in the OFF or 0

position.

5.7 What is Power Saving? (GPSW1000, GPSW2000 and

GPSW3000)

Power saving mode enables the inverter to be “on” and waiting for a load, yet

draw very little power. When power saving is enabled and the inverter senses a

load, it may take one second for the load to become active. This one-second wait

will be fine for loads that draw continually, such as televisions and stereos.

However, it may not be suitable for loads that are intermittent such as bread

makers, power tools or blenders. Power saving will continually draw a small

amount of power from the batteries, so if the inverter will not be in use for longer

than a day, it is advisable to turn the inverter off using the on/off switch located

on the front of the inverter or remote

5.8 Remote

The GPSW1000, GPSW2000 and GPSW3000 are available with an optional

remote (GPSWR-B). The remote will turn the inverter on and off and indicate

normal operation or any faults that have caused the inverter to shut down. The

remote will show battery voltage and power consumption.

The remote will show if the battery voltage is too high and will sound an alarm if

the battery voltage falls too low (Under Voltage). The remote will also sound an

alarm if the output power is above the inverter specifications (Overload). The

Under Voltage and Overload alarm consists of five single beeps every eight

seconds.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Go-power GP-SW1000 User Manual Page 16